generique:import_config_prusaslicer [Wiki Tobeca]

Cette page est en lecture seule. Vous pouvez afficher le texte source, mais ne pourrez pas le modifier. Contactez votre administrateur si vous pensez qu'il s'agit d'une erreur.

====== How to import Prusa Slicer configurations ? ======
After the installation of Prusa Slicer, you need to launch once the software and then close it.

After that, some files are created in this folder : 

**Windows :** ''C:\Users\VOTRE_UTILISATEUR\AppData\Roaming\PrusSlicer\''

Note : the folder AppData is a hidden folder, so you need to have the right explorer parameters in order to display it.

After that, you need to copy/overwrite 3 folders in this folder, which are :

  * filament : for filament settings
  * print : for parameters of the prints
  * printer : for the settings of each printer

At the end of the copy, the folder should look like this :

{{ :generique:prusa_slicer_conf.png |}}

Launch again the software and you should be good to see the new parameter sets in the dropdown boxes.

After that, launch again